Support

How place the Ratio^® Shield to my iDive.

Clean and dry the top-glass of your iDive with a lens cleaning cloth ^{(not included)}.
     Warning: Do not use any kind of solvent or chemical to clean the iDive. Use warm water only in needed.




Prepare the Shield for the application, make sure to not touch the bottom part of the Shield.
     Warning: Touching the bottom part of the Shield will cause a not perfect application on the iDive.




Place the Shield starting from one side of the bezel as shown



Place the Shield an press it. Make particular attention at the sides of the Shield in order to not let the water go between the Shield and the top-glass of the iDive.
     Do not remove the Shield even if some air is present under the Shield. After a couple of dives over 10-15mt the water pressure
     will remove for you all the imperfections under the Shield.




The Shield is naturally subject to wear once placed on the iDive.
Change the Shield with a new one when needed.